Heltec Automation

Establishing connection

HELTEC image
HELTEC KNOWLEDGE NETWORK / FAQ DETAIL
Q

## Heltec v3 Keeps Rebooting

Public FAQ1 response1 from Heltec team
01 / RESPONSE STREAM

Answers & Discussion

01 ENTRIES

Follow the conversation from the Heltec team and the community.

  1. Heltec teamOFFICIAL RESPONSE

    According to the situation we have collected so far, the most likely to cause a constant reset problem may have three reasons: – Insufficient Power Supply Current The board may reboot intermittently if the connected USB power source cannot deliver adequate current. Ensure your power supply provides at least 600 mA of stable 5V DC output. – Wi-Fi spring Antenna Damaged or Compressed by Enclosure Recommend removing the enclosure and testing the board in open air. If using a case, verify that no part of the plastic or metal structure presses against or covers the antenna area (typically near the ESP32 module edge). ![](<https://heltec.org/wp-content/uploads/2025/11/v3-300x204.png>) – Incorrect or Incompatible Firmware Flashed to LoRa 32 V3 Please flash firmware compiled or verified for LoRa 32 V3. Double-check board selection in your IDE. If unsure, reflash the official factory demo or the latest stable firmware from the manufacturer’s github repository.