Heltec Automation

Establishing connection

HELTEC image
HELTEC KNOWLEDGE NETWORK / FAQ DETAIL
Q

## How to enable the GNSS IPEX antenna interface

Public FAQ1 response1 from Heltec team
01 / RESPONSE STREAM

Answers & Discussion

01 ENTRIES

Follow the conversation from the Heltec team and the community.

  1. Heltec teamOFFICIAL RESPONSE

    The development board is connected to the LDS antenna by default. If you need to use the IPEX interface to connect an external GNSS antenna, as shown in the figure below, move the resistor in the **red box①** half a grid to the position of the **greenbox②.** ![](<https://heltec.org/wp-content/uploads/2026/06/t096-gns-300x145.png>)