Heltec Automation

Establishing connection

HELTEC image
HELTEC KNOWLEDGE NETWORK / FAQ DETAIL
Q

## How to make the antenna connection to the SMD pin?

Public FAQ1 response1 from Heltec team
01 / RESPONSE STREAM

Answers & Discussion

01 ENTRIES

Follow the conversation from the Heltec team and the community.

  1. Heltec teamOFFICIAL RESPONSE

    The default antenna interface is an IPEX connector. If you need to connect the antenna to the pins instead, simply rotate the resistor marked in the diagram below by 90 degrees to establish the connection to the corresponding pin. ![](<https://heltec.org/wp-content/uploads/2026/01/HC02-ANT-pin-300x300.png>)