Heltec Automation

Establishing connection

HELTEC image
HELTEC KNOWLEDGE NETWORK / FAQ DETAIL
Q

## GNSS antenna

Public FAQ1 response1 from Heltec team
01 / RESPONSE STREAM

Answers & Discussion

01 ENTRIES

Follow the conversation from the Heltec team and the community.

  1. Heltec teamOFFICIAL RESPONSE

    The resistor at the arrow position is connected to the onboard antenna by default. After rotating it 90 degrees and soldering it to the position in the red box, the onboard antenna will be disconnected and the connection will switch to the IPEX interface. You can directly use a 0-ohm resistor to short-circuit the boxed position, but in this case, both the onboard antenna and the IPEX interface will be enabled simultaneously, which may affect the signal. ![](<https://heltec.org/wp-content/uploads/2026/03/19296743-43ce-43ef-9a8e-275917f0bafd-300x124.png>)