Heltec Automation

Establishing connection

HELTEC image
HELTEC KNOWLEDGE NETWORK / FAQ DETAIL
Q

###### Unable to flash firmware / Unable to connect to serial port

Public FAQ1 response1 from Heltec team
01 / RESPONSE STREAM

Answers & Discussion

01 ENTRIES

Follow the conversation from the Heltec team and the community.

  1. Heltec teamOFFICIAL RESPONSE

    1. **Enter the Bootloader mode**: connect the USB cable, press and hold the ‘USER’ key, then press the ‘RST’ key once. Finally, release the ‘USER’ key. 2. **Try a different data cable**.Check if the USB cable supports data transfer by verifying if the connected cell phone supports file transfer. 3. To eliminate static interference, a common method is to hold the USB-C interface of the board with one hand while touching a well-grounded metal object, such as a metal water pipe in your home, with the other hand. 4. If your operating system is Windows 7/8, you need to install the driver: [ESP32 USB-Serial-JTAG](<https://dl.espressif.com/dl/idf-driver/idf-driver-esp32-usb-jtag-2021-07-15.zip>)