Answers & Discussion
01 ENTRIESFollow the conversation from the Heltec team and the community.
- Heltec teamOFFICIAL RESPONSE
**For the screenless version, the 2.4 GHz antenna is connected to the IPEX connector by default.** For the OLED version,The default 2.4G FPC antenna is located on the side of the plastic screen bracket.
**Hardware 4.2** If you wish to use an IPEX-connected 2.4G antenna, you need to remove the inductor marked as**①**in the diagram below, and add a 0-ohm resistor (or other conductive metal or cable) at the position marked **②** to connect to the IPEX interface. **Hardware 4.3** move the resistor from Mark 2 to the position of Mark 1
**Why is it designed this way?** By default, it is connected to the onboard FPC, and its circuit has been tested to achieve optimal performance. When you switch the resistor to IPEX, the IPEX connector will achieve optimal performance. If both the IPEX interface and the FPC contacts are connected at the same time, the communication performance on both sides will be degraded. This is a 0-ohm resistor. If you don’t have high requirements for the 2.4G signal, you can directly use a soldering iron to short-circuit both directions at once, making both sides work simultaneously.