The default 2.4G FPC antenna is located on the side of the plastic screen bracket.

If you wish to use an IPEX-connected 2.4G antenna, you need to remove the inductor marked as ① in the diagram below, and add a 0-ohm resistor (or other conductive metal or cable) at the position marked ② to connect to the IPEX interface.

• Arduino
• Micro Python
• Platform.io
• Espressif IDE

We strongly recommend using Arduino. We have complete technical support and provide complete LoRaWAN code for ESP32 Arduino framework.

You can find this type of socket by search “SH1.25 x 2”.

Of course, you can contact our sales staff and provide your ideas.

They are compatible in most scenarios.
Since V4 uses the same series of chips as V3, features the same OLED, and has an almost identical pin layout, V3 and V4 can be used interchangeably in the majority of cases.
However, due to the increased transmit power, the transmit power settings in some code may no longer correspond directly to the actual output.

Please try the following steps:

1. Try using a different USB cable.

2. Enter BootLoader mode. There are two methods to enter this mode:

• Hold down the PRG button, connect the USB-C cable, then release the PRG button.

• Connect the USB-C cable, hold down the PRG button, press the RST button once, then release the PRG button.